Upcoming Training

January 2020

January 15, 2020

Geometric Dimensioning and Tolerance (GD&T)

8:00AM - 4:00PM
NSA Industries, St. Johnsbury, VT

Engineering Drawings are the fundamental method used to convey technical information to manufacturing and inspection.  Geometric Dimensioning and Tolerance (GD&T) is a common manufacturing language[…]

January 16, 2020

Principles of Lean Manufacturing 101

8:00AM - 4:00PM
Burton Snowboards, Burlington, VT

In order for the simulation to run effectively, we need a minimum of ten (10) participants in this training; if this number is not met by[…]

February 2020

February 04, 2020

Principles of Lean Manufacturing 101

8:00AM - 4:00PM
Chroma Technology Corporation, Bellows Falls, VT

In order for the simulation to run effectively, we need a minimum of ten (10) participants in this training; if this number is not met by[…]

February 25, 2020

Value Stream Mapping: Planning, Leading and Executing

8:30AM - 4:30PM
VTC Williston campus, Classroom 215, Williston, VT

NOTE: For this training session, February 26 Root Cause Analysis training and February 27 Mistake-Proofing training ONLY, we will offer a $50 per person discount[…]

February 26, 2020

Root Cause Analysis

8:30AM - 4:30PM
VTC Williston campus, Classroom 215, Williston, VT

 NOTE: For this training session, February 25 Value Stream Mapping training and February 27 Mistake-Proofing training ONLY, we will offer a $50 per person discount[…]

February 27, 2020

Mistake-Proofing for Manufacturing and Administrative Processes

8:30AM - 4:30PM
VTC Williston campus, Classroom 215, Williston, VT

NOTE: For this training session, February 25 Value Stream Mapping training and February 26 Root Cause Analysis training ONLY, we will offer a $50 per[…]

March 2020

March 31, 2020

ExporTech – Spring 2020

8:00AM - 5:00PM
Hampton Inn, Colchester, VT

Growth opportunities exist in global markets, but are you struggling to carve out the time and resources to seize them? ExporTech™ could be your answer![…]

May 2020

May 12, 2020

Geometric Dimensioning and Tolerance (GD&T)

8:00AM - 4:00PM
Hampton Inn, Colchester, VT

Engineering Drawings are the fundamental method used to convey technical information to manufacturing and inspection.  Geometric Dimensioning and Tolerance (GD&T) is a common manufacturing language[…]